TM
Assembly Instructions
The assembly of the
BreezeShield
is very easy and begins by laying the 4 panels out on a flat surface.
The 2 panels with 4 holes are located between the panels with
only 2 holes. All panels should be oriented with the white
painted surface facing up.
The rings are installed by opening each and connecting the adjacent
panels together through the punched holes. If a ring does not
click firmly into place, merely bend the open ring against the hinge to
tighten it so that when it is clicked back together it is tight.
Please note that all effort has been taken to ensure high quality for
each panel. Caution should be taken to make sure that there
are no sharp edges while assembling.
Please Note:
BreezeShield is a sturdy product designed to be used
around heat sources. However, one should use caution to not
expose the BreezeShield to direct heat. Prolonged contact
with
direct heat may cause damage to the BreezeShield. The
BreezeShield is
not
designed to
be used as a cooking surface. Care should be
taken when
handling the BreezeShield as it may be hot after being in close
proximity to heat sources.
Pat. Pending. BreezeShield is a trademark of BreezeShield.com and
manufacturer. This web site is the Intellectual Property of
designer. All sales are final. In the event of a
defective part, a
replacement will be sent if notification has been recieved within 15
days of shipment via email to admin@breezeshield.com.
